Carbide Tipped Beveling and Chamfering Router Bits

Two & Three Flute Router Bits

With ball bearing rub collars.

The solid construction of these carbide-tipped bits reduces vibration, and its two or three-flute configurations produce very smooth cuts. Intended for use in a standard router.

Use the three flute models were you need the best possible finish.

Includes: Cutter, Arbor, and Ball Bearing Guide

An assembly offers the option of switching cutters—from flush trim to either of two bevel trims—without removing the bit from the router or even changing the depth-of-cut setup. Four flutes yield a smooth, crisp cut finish. All parts can be replaced individually.

Includes: Cutters, Arbor, and Ball Bearing Guide

Trim both edges of a countertop in a single pass with this assembly. Four flute cutters ensure a smooth cut finish. Cutters can be switched with the bit secured in the router and without changing depth of cut setting. Not intended for use in a laminate trimmer.

Cutters for the above assemblies are available seperately.

Chamfer or bevel edges for decorative effect or to form edge miter joints. Produce crisp, uniform edges at accurate angles to make 4-, 6-, 8-, 12-, or 16-sided boxes. For best results use in a router table!

Chamfer both corners of an edge in one pass with this assembly. Switch
from 30° or 45° chamfers by switching cutter positions on the arbor. Interchangeable spacers adjust assembly to accommodate different stock thicknesses. The assembly includes the arbor, a pair of multi-angle cutters, pilot bearing, spacers, and shims. Replacement parts are available separately. For best results use in a router table!

Max Material Thicknesses:

1-5/8" for 45° Chamfers

1-1/2" for 30° Chamfers