Interlocking Shaper Cutters

Drawer Lock Cutter

Matched Drop Leaf Cutter

Reversible Pattern Cutters

Reversible Glue Joint Cutters

Double Tongue & Groove Lock Mitre Cutter

Single Tongue & Groove Lock Mitre Cutter

Mini-Pro Cutters:

• 3 Wing

• 2-15/16" Diameter

Pro-Line Cutters:

• 3 Wing

• 5" Diameter

Run drawer front face up in horizontal position over the top of the cutter.
Drawer sides are run on end in a vertical position against the shaper fence.
Made to cup up to 3/4" drawer sides.

Counterclockwise rotation only.

Mini-Pro Cutters:

• 3 Wing

• 2-15/16" Diameter

Pro-Line Cutters:

• 3 Wing

• 5" Diameter

Counterclockwise rotation with wood face down. When running counterclockwise, cove cut is made by lowering sharper spindle to cut with the top half of the cutter. Bead cut is made by raising shaper spindle to cut with the bottom half of the cutter.

Each set includes 2 cutters and 2 spacers to cut 3/4" , 1", 1-1/4" and 1-1/2" material.

Mini-Pro Cutters:

• 3 Wing

• 2-15/16" Diameter

• 1" Cutting Edge

Pro-Line Cutters:

• 3 Wing

• 4" Diameter

• 1" Cutting Edge

After machining two pieces of wood, one piece may be inverted and plugged into its mate forming a matched joint.
Counterclockwise rotation with wood fed face up.

Mini-Pro Cutters:

• 3 Wing

• 2-15/16" Diameter

• 1" Cutting Edge

• Cuts material from 1/2" to 7/8"

Pro-Line Cutters:

• 3 Wing

• 2-15/16" Diameter

• 2" Cutting Edge

• Cuts material from 1/2" to 1-7/8"

Mini-Pro Cutters:

• 3 Wing

• 4.05" Diameter

• 1-1/8" Cutting Edge

• 3/4" Spindles Only

Pro-Line Cutters:

• 3 Wing

• 5.05" Diameter

• 1-1/8" Cutting Edge

Double Tongue and Groove runs counterclockwise only. Mini-Pro is made to run only on 3/4" spindle.

Part A is run flat in horizontal position on shaper table.

Part B is is run in a vertical position against the shaper fence.

Mini-Pro Cutters:

• 3 Wing

• 4-5/16" Diameter

• 1-1/8" Max Material

• 3/4" Spindles Only

Pro-Line Cutters:

• 3 Wing

• 5-3/8" Diameter

• 1-1/8" Max Material

Single Tongue and Groove runs counterclockwise only. Mini-Pro is made to run only on 3/4" spindle.

Part A and B are both run flat in horizontal position on shaper table.

Part B is is run again on table saw to cut groove.