Phone # 1- 800-678-3313 Fax: 1-616-241-1506 Store & Phone Hours: M-F, 8 - 4:30 EST Established 1969
We Accept:
Raised Panel Cutters for 3/4" Material
Raised Panel Cutters for 5/8" Material
Back Cutters - Raised Panel (3/4" Material)
Raised Panel Tongue Trimmer
Raised Panel Cutters for 1/2" Material
Mini-Pro Cutters:
3 Wing
4-1/2" Diameter
Run with 1-5/8" Rub Bearing (AM-90-026)
Pro-Line Cutters:
6" Diameter
Run with 3" Rub Bearing (AP-90-048)
Our raised panel cutters are manufactured with 15º shear to produce optimum cuts both with and across the grain. Counterclockwise rotation with wood fed face up.
Use with the back cutters shown below to cut 3/4" material.
3-3/8" Diameter
4-3/4" Diameter
Manufactured with 15° shear to produce optimum cuts both with and across the grain. Counterclockwise rotation with wood fed face up. Spacer provided to allow 1/4" tongue as shown. Spacer can be replaced with optional 1-5/8" or 3" rub bearing. Runs with any M-55 or P-15 Series raised panel cutter to cut 3/4" panels.
Runs with any of our stock raised panel cutters to trim the end of tongue for cabinet doors.
Designed to run with a 3" diameter rub bearing (AP-90-048)
Available in Pro-Line Only.
Manufactured with 15° Shear to produce optimum cuts both with and across the grain.
Counterclockwise rotation with wood fed face up.
These raised panel cutters cut a 1-3/8" reveal plus a 3/8" long tongue.
Reduce production time by adding an opposite rotation cutter to those above, and produce double sided raised panels in a single pass.
© 2008 Carbide Specialties Incorporated
Report problems or suggestions to our Webmaster.
