Laminate Blades

Freud® LU97 Industrial Double Sided Laminate/Melamine Blades

Freud®  LU98 Industrial Single Sided Laminate & Wood Blades

Freud® LU92 Industrial Thick Stock Laminate Blades

Freud® LU96 Industrial Thin Kerf Laminate Blades

FS Tool LM6 Chip-Free Melamine Trim Blades

FS Tool L41 Hollow Face Saw Blades TCH

FS Tool L42 Hollow Face Saw Blades VH

Designed to give long life and excellent finish on the top and bottom of laminates, melamine & veneered plywood. The laser-cut anti-vibration design yields the plate acoustically dead. This reduces the sideways movement of the cutting edge to prevent chipping in manmade materials such as laminates. This dramatically extends cutting life and finish. No scoring blades needed with this blade!

This fast-cutting blade is ideal for a perfect finish on one side of laminates and melamines. The Perma-SHIELD™ coating makes these blades resistant to friction and heat build-up. Coated blades pull 1/3 less on the saw, which translates into 33% more cutting power. The 10° hook angle and a triple chip grind provide fast cuts and long cutting life.

This heavy-duty production blade produces an excellent finish on the top and bottom of thick laminates and melamine. The LU92M series is ideal for cutting stacked 3/4" laminates and melamine. Each tooth has a special modified triple chip grind design created by computer simulation to breeze through thick stock and single or double-sided laminates, leaving a chip-free edge.

The LU96R is a thin kerf blade that is designed to give long life and excellent finish on the top and bottom of laminates, melamine & veneered plywood. The laser-cut anti-vibration design yields the plate acoustically dead. This reduces the sideways movement of the cutting edge to prevent chipping in manmade materials such as laminates. This dramatically extends cutting life and finish. No scoring blades needed with this blade!

• Tooth configuration: High ATB (30°)
• Cutting material: TC
• Expansion slots: Cu plugged

A P P L I C AT I O N :

• For chip-free sizing cuts (on both sides) in melamine and wood veneered panels, without the need for pre-scoring
• For fine cross cuts in solid woods
• On table saws, sliding table saws, vertical panel sizing saws and cut-off saws

• Tooth configuration: TCH (face hollow-ground)
• Cutting material: TC
• Expansion slots: Cu plugged

A P P L I C AT I O N :

• For exceptionally smooth cuts (on both sides) in melamine and other
  laminated panels, without the need for pre-scoring
• On table saws, sliding table saws and vertical panel sizing saws

D E S I G N :

• Tooth configuration: inverted “V” (face hollow-ground)

• Cutting material: TC

• Expansion slots: Cu plugged

A P P L I C AT I O N :

• For exceptionally smooth cuts (on both sides) in melamine and other
  laminated panels, without the need for pre-scoring

• For mitre cuts in wrapped styrene picture frames

• On table saws, sliding table saws, vertical panel sizing saws and mitre saws