Ripping Saw Blades

Freud® LU87 Industrial Thin Kerf Rip Blades

Freud® LM72 Industrial Heavy Duty Rip Blades

Freud® LM74 Industrial Glue Line Rip Blades

Freud® LM71Thick Stock Rip Blades

FS Tool L21 Standard Rip Saw Blades

FS Tool L21TK Thin Kerf Rip Saw Blades

FS Tool L18 Heavy Duty Rip Saw Blades

FS Tool L02 Rip Saw Blades with Chip Limiters

FS Tool L12 Gang Rip Saw Blades with Chip Limiters

FS Tool L2A Glueline Rip Saw Blades ATB

FS Tool L22 Glueline Rip Saw Blades TCG

This blade gives new life to underpowered table saws and radial arm saws because the thin kerf does not require much horsepower. The Perma-SHIELD™ coating helps this blade pull 1/3 less on the saw, which translates into over 33% more cutting power. The ideal working range is from 3/4" to 2-3/4" thick.

This blade gives smooth, fast rips in hardwoods and softwoods. The combination of a rigid blade body and razor sharp flat top carbide teeth will provide a "glue line" precision cut. These blades are precision balanced and can be used in gang-rip operations. The ideal working range is from 3/4" to 2-3/4" thick. This blade also features laser cut anti-vibration slots, practically eliminating the vibration that resonates in standard blades. With this ultimate ripping blade, there is no need for stabilizers.

This blade’s specially designed triple chip tooth design produces extremely smooth, true surfaces for gluing and finish work. There is no need for sanding or jointing after the cut. The ideal working range is from 1/8" to 1" thick. This blade also features laser cut anti-vibration slots, practically eliminating the vibration that resonates in standard blades. With this ultimate ripping blade, there is no need for stabilizers.

This blade is ideal for high-speed ripping operations in hardwood and softwood. The low tooth count also makes this blade ideal for ripping thick material. It can be used with manual feeding as well as with power feeders in single or gang-ripping operations. The ideal working range is 1-1/2" to 3-1/2" thick. Thinner or thicker material may be cut, but some loss of surface finish may occur.

• Tooth configuration: Flat Top
• Cutting material: TC
• Expansion slots: Cu plugged

A P P L I C AT I O N :

• For ripping dry soft and hardwoods
• On table saws or gang-rip saws with one or two shafts